Page 30 - All Scale Rails Magazine Issue 4 September October 2015
P. 30
www.AllScaleRails.com
Pull or push the excess wire through the
board. Now the wire is prepped and ready to
be soldered to the track. Push the wire up
against the outside of the rail, in the indent in
the side of the rail to make sure it is bent the
right amount. This is where you are going to
be soldering the wire to.
Dip a toothpick in the flux.
Pull the wire away from the rail and, using the
toothpick, apply the flux to the outside of the
rail next to the hole, specifically where the
solid strand wire is going to go.
The wire and the rail should have the flux be-
tween them.
30 All Scale Rails
